Troubleshooting Reinstall via LiveSuit
Installing MOD Duo via LiveSuit
WIP notes only
mention tool is not made by MOD
needs driver install
mod needs to be disconnected before starting livesuit?
Installing FEL mode USB driver
1. Press the windows key and 'R' at the same time to get the 'Run' dialog. Type "devmgmt.msc" and press enter. (This will open the Device Manager)
2. Find the MOD Duo device. It should appear as 'Unknown device' under 'Other devices' like the image below shows.
3. Right click on the selected item and select 'Update Driver Software...'.
4. Select 'Browse my computer for driver software'
5. Click the 'Browse' button and select the folder where you extracted the contents of the LiveSuit1.0.7.zip file, then click 'Next'.
6. Wait for Windows to finish installing the driver.
Windows might complain that it can't verify the publisher of this driver. You'll have to click to install anyway.
(This is because, as previously stated, this software was not done by the MOD Team)
7. That's it! The driver is installed. :)
8. If everything is working correctly, the Duo will appear as 'USB Device(VID_1f3a_PID_efe8)' under 'Universal Serial Bus controllers'
Deploying LiveSuit image
1. Double-click on the PhoenixSuit file to open it. The application looks like this:
2. Download...
On the LiveSuit application window, click on the Firmware tab and then the 'Image' button and select the file you just downloaded.
3. When asked about a forced format, click 'yes'.
4. Wait while the deploy takes place.
5. Deploy should complete in about 30 seconds.
The MOD Duo will automatically boot into restore mode after the deploy.
Grab the latest release image from [Releases] and copy it to the mass storage device (as usual for MOD updates).
Just note that for LiveSuit deploys, version 1.4 or higher is required.
